Towns · Viking
Viking Refrigeration Repair in Andover
Viking built-ins are professional-style appliances in domestic kitchens, and the thing that most defines them is the door: full stainless, heavy, and hung on a cam hinge that lifts it as it opens. Andover has a lot of them, in large colonials where the kitchen has been extended at the back.
Flat $95 service call — the trip and the diagnosis — credited against the repair if you approve one. 8:00 am – 8:00 pm, seven days.
The hinge cam is the part to know about
A Viking door is lifted slightly by its hinge as it swings and set back down as it closes. When the cam wears, the door stops being lifted cleanly and starts to drop — the visible sign is a door that no longer lines up with the one beside it, and the invisible sign is a gasket that has stopped sealing at the bottom corner. Warm air enters there, the evaporator ices unevenly, and the complaint arrives as poor cooling rather than as a door problem.
Then the fan, then the defrost
After the door, the two components that account for most Viking refrigeration calls are the evaporator fan motor and the defrost circuit. A fan slowing down starves the fresh-food compartment while the freezer stays cold, which is a very characteristic split. A defrost heater or termination sensor that has failed builds a sheet of ice on the evaporator until airflow stops altogether, and that presents the same way — so the two are separated by looking, not by guessing.
Andover kitchens
The larger houses out here usually have the room to pull a unit forward, which makes condenser access and rear-panel work straightforward. In the older centre streets that is less true, and the repair is planned around the opening it sits in.
Reviews
Written after a Winchester-area visit
4.9out of 5across 1054 reviews
5 out of 5
Butler pantry unit in a townhouse off Route 38 with barely any clearance. He measured before pulling it and laid blankets down. A slipping door cam had the seal sitting proud and letting warm air in.
Terrence B.Woburn
5 out of 5
The arm was stuck in its raised position and nothing we tried brought it down. Gearbox in the module had stripped. New module, cabinet levelled, and he showed me the test button hidden behind the cover.
Padraig S.Woburn
5 out of 5
Our lower level unit tripped its breaker during the heat. He found a bulging fan capacitor and a wiring nut backed off in the base. Both fixed, then he checked the circuit load before switching it on.
Vance Y.Arlington
Keep reading
Pages next to this one
Book the visit
Winchester and the towns around it — the model number and the symptom is enough to start.
(781) 675-1098Flat $95 service call, credited against an approved repair.